Comparison between finite element analysis and rheological models for chip formation

Authors

  • Olga Liivapuu Institute of Technology, Estonian University of Life Sciences, Kreutzwaldi 1, 51006 Tartu
  • Jüri Olt Institute of Technology, Estonian University of Life Sciences, Kreutzwaldi 1, 51006 Tartu
  • Tanel Tärgla Institute of Technology, Estonian University of Life Sciences, Kreutzwaldi 1, 51006 Tartu

DOI:

https://doi.org/10.12697/ACUTM.2019.23.22

Keywords:

chip formation, elastic and plastic deformation, rheological model, finite element method

Abstract

In the process of cutting, often the selection of cutting parameters is done considering empirical methods. This approach is more expensive and does not usually lead to the best solutions. Numerical methods for simulating the chip formation have been under development over the last thirty years. The aim of the present research is to compare models based on rheological properties of metals with 2D Finite Element Models of chip formation process.

Downloads

Download data is not yet available.

Downloads

Published

2020-01-14

Issue

Section

Articles